MCD 4.1 on MXe III

[danramirez]

Guys,

Can I install MCD4.1 on an MXe III Controller?

I am too lazy to go through the release notes and self study courses.

Thanks a lot, regards,

Daniel

http://www.hatkana.com

http://www.wtelecom.com

 

[LoopyLou]

Yes, The MXe III will take as low as MCD 4 but only with SP4 which I belive was created just so MCD 4 would work on an MXe III

Lazy bitch

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[danramirez]

Loopy, what's software load for MCD4 SP4?

BTW, have you got that release notes?

4.1 not available on MOL...

Regards,

Daniel

http://www.hatkana.com

http://www.wtelecom.com

 

[LoopyLou]

I don't typically pay attention to the load numbers if that is what you are asking. Checked the MOL site and it shows 10.0.4.14. The release notes are there as well. You are correct I can't see any MCD 4.1 load. You might have to contact product support but since you don't say if your site is a cluster why not put MCD 4.1. It is still available for download.

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.