Maximum of participants in a conference Hipath 4000 - Openstage 40

[schoeffner]

Hi guys,

we would like to start a conference with more than 3 external participants. If the user tries to invite more than 3 externals, the process cancels.
Is there an option to set a maximum of participants in a conference?

Thank you.

 

[sbcsu]

Try the following:

ADD-WABE:**900,,,CONF,N;
CHANGE-FEASU:TYPE=A,CM=VARCONF;

 

[adibv]

Hi.

On old sys versions:
Customer could not add more then 2 external numbers in a conference.
And up to 7 internal participants.
Cannot tell for newer sys versions.

Additionally you may check the following:
- in the COT of TIE trunk (4k <-> external number) param. NOHO should not be added (No Hold for NW Conference).
- param XFER in COT should be present
- and check param NOCI,NOCT in COT - make some tests with and without them and observe the behavior
- in ZAND:alldata - param CONFSUB = YES (allow external subscribers)
- also in WABE, code for TIE trunk with external should have CPS=22 added (Consultation of station user from conference).

 

[schoeffner]

Thank you for your suggestions, I will give you some Feedback asap.

 

[LoPath]

From HiPath 4000 V6, Section 3 - Feature Usage Examples, Service Documentation, Issue 6

149.4
Generation

• Activate variable conference in the system:
The activation of VARKONF is only possible in expert mode.
Expert Mode --> HiPath 4000 --> HiPath 4000 Expert Access --> Open ...<IP> with AMO (see AMO command)

CHANGE-FEASU:TYPE=A,CM=VARCONF;

• ADD DAR for conference:
Configuration Management --> Tables --> Dial Plan --> Dial Codes, Click New. Enter Dial Code and select CONF as Code Type. Click Save.

ADD-WABE:CCD=91,DAR=CONF;

• Change display time of conference information (if wanted):
The time how long the conference information is displayed on a digital phone can be performed in expert mode.
Expert Mode --> HiPath 4000 --> HiPath 4000 Expert Access --> Open ...<IP> with AMO (see AMO command)

CHANGE-DTIM1:TYPEDH=DIGITE,VWKONFMB=<sec>;






LoPath
Maintain HiPath 4000 V5 & V6, OpenScape Xpert V4, OpenScape Xpressions, OpenScape Contact Center V8, OpenScape Voice V9