I have Mat integrated with a Opt61C Rls 25 issue 15. Mat has been working fine for 2 years on the older PC. That PC's Harddrive crashed so I installed it on a new PC. After setting up MAT on the new PC everything works great. I retrieved all and have been using it for digital sets for about a month now. I went to change a 500 set and when it goes to transmit in its blind as a bat typing mode it gets lost. It logs in ok then goes to LD 10 ok. Then it types:
REQ CHG
TYPE 500
TN 4 0 0 1
up to this point all is ok.
Then it Enters past the ECHG field and the DES field, all is still ok, the next prompt is WRLS which auto fills out on this switch with a NO and then skips to the next field so when the switch is asking for a DN the stupid MAT tries to type NO for the previous field so it just and ends the process. I hope I explained this ok and if anyone knows what to change it would be greatly appreciated. If more info is needed ask away.
REQ CHG
TYPE 500
TN 4 0 0 1
up to this point all is ok.
Then it Enters past the ECHG field and the DES field, all is still ok, the next prompt is WRLS which auto fills out on this switch with a NO and then skips to the next field so when the switch is asking for a DN the stupid MAT tries to type NO for the previous field so it just and ends the process. I hope I explained this ok and if anyone knows what to change it would be greatly appreciated. If more info is needed ask away.