MASTER - SLAVE OSBIZ X8 : Firmware compatibility

[Hertz]

Hello Gents,

Just a question about firmwares of a MASTER - SLAVE OSBIZ X8 setup.
Can I use a higher version of FIRMWARE for my SLAVE OSBIZ x8? Same version and release. Only the "." differences.
Currently using a Osbiz_V1_R3.3.0.552 and planning to upgrade it to R3.4.1566.

any thoughts? Thanks

Best
Hertz

 

[xs650]

Normally master and slave should use the same firmware.
Anything else is not supported by Unify.
But in my systems this was working.

 

[Hertz]

@xs650

Im about to simulate now hope will work

Best
Hertz