Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

master guide lines problem

Status
Not open for further replies.

rodoftex

Technical User
Mar 24, 2006
7
US
Somehow during the development of a project it got put on the "master guidelines layer" of Corel Draw. I am unable to extract it and get it back on layer 1 and can't print it (laser engraver) as is. I have a lot of time invested in this project and hate to start all over. Any help would be appreciated. thanks.
 
You should probabl;y post this in the Coreldraw forum as it is where it most likely will get thwe best response.

Here is the Corel Draw Forum: forum238


----------------------------------
Ignorance is not necessarily Bliss, case in point:
Unknown has caused an Unknown Error on Unknown and must be shutdown to prevent damage to Unknown.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top