Marp Issue???

[shug1]

Guys, I have a analog phone 500 that the main # is 8018, line 1 4204, line 3 4207 arent ringing, line 2 4205 rings and line 4 4208 rings. Below is the print off the main # what can I look at to see why lines 1 & 3 dont ring?
DES IVR1
TN 004 1 11 07
TYPE 500
CDEN 4D
CUST 0
WRLS NO
DN 8018 0 MARP
AST NO
IAPG 0
HUNT 4205
TGAR 10
LDN NO
NCOS 5
SGRP 0
RNPG 0
XLST
SCI 0
CLS UNR DTN FBA XFA WTA THFD FNA HTA ONS
LPR XRD AGRD CWD SWD MWD RMMD SMWD LPD XHD SLKD CCSD LND TVD
CFTD SFD C6D CNID CLBD AUTU
ICDD CDMD EHTD MCTD
GPUD DPUD CFXD ARHD OVDD AGTD CLTD LDTD ASCD
MBXD CPFA CPTA DDGA NAMA MIND
MCRD SHL ABDD CFHD
USRD BNRD OCBD RTDD RBDD RBHD FAXD PGND FTTC
RCO 0
PLEV 02
AACS NO
FTR FDN 8200
DATE 27 FEB 2004

 

[notme11]

AN ANALOG PHONE ONLY HAS ONE LINE,the other lines are different TNs going to different phones that may hunt to 8018, thare is no reason for 4202, 4207, 4205 or 4208 to ring on this phone unless as stated before the other sets are FDN 8018, hunt 8018 and this will only happen after the original phones are busy or no one answers...
the other way is to have those numbers pointed to 8018 via an IDC table in LD 49, or the CO does this for you...

 

[johnpoole]

do you have more then a single tn sent to that set? you can have a multi line analog but they require a tn per line.. and the ring is at the set level, not the software..

john poole
bellsouth business
columbia,sc

 

[GHTROUT]

Print all of the TNs and you will see a pattern of one hunting to the other. Verify each has CLS HTA and has the correct HUNT to the next phone

~

http://www.GHTROUT.com/