Margins in runtime 2000

[MDJ52]

I have a report that I have developed in Access 2000. The report is large enough that I have set all margins to .5".
When the client puts the software onto a system that is using runtime, the margins revert back to a default of 1".
Being runtime, you cannot modify the report.
Is there a way in runtime to set the default margins to something other than .5" ?
Thanks

 

[Remou]

I seem to recall that if you change to Use Specific Printer, the margins will stick. You will need to install the relevant printer on the development PC.

Then there is this:

http://groups.google.ie/group/microsoft.public.access.reports/browse_thread/thread/36f986331f0459d4

But I have not tried it, it seems a little unlikely.

 

[MDJ52]

I do have the report set to go to a specific printer. We are sending it to a PDF creator software where it creates a pdf on the harddrive so it may be attached to an email.

 

[Remou]

Just guessing ... have you switched off Name Autocorrect? Have you installed all the service packs for Access?

 

[MDJ52]

Switching off autocorrect is a standard for us. I did check this and autocorrect is turned off.
Yes all service packs have been downloaded.