Manager not showing analog trunk card correctly 1

[Trason806]

I have a IP Office 500v2 9.0.9.0 - 995. Have a analog combo card in slot 1. Manager sees line 1 2 3 4 but all of them say Line Number 1, Card/Module 1, Port 9. System Status see them correctly.
line: 1 slot :1 port 9
line: 1 slot :1 port 9

 

[Trason806]

line: 1 slot :1 port 9
line: 2 slot :1 port 10
line: 3 slot :1 port 11
line: 4 slot :1 port 12

I have reseated the card and even reseated the trunk board onto the combo card. Any ideas?

 

[holdmusic34]

Your config is corrupted.
Back up the config- handy when you need to rewrite it.

1: Shut down system
2: Remove the card
3: Power up system
4: Delete the card
5: Immediate merge
6: Shut down system
7: Insert card
8: Reprogram lines and deleted extensions.
9: Didn't work? Corrupt config. Write new offline config and merge or restore from a previous backup.

Save Ferris.

 

[Trason806]

Thanks. This is a test system so i ended up doing a: File>Advanced>Erase Configuration (Default). That took care of the problem. But I did not realize it would wipe the licensing. Good thing i still had them.

 

[amriddle01]

Yeah, this is something new and exciting Avaya introduced in R9, they must have thought we were getting bored or something and a little corruption would spice things up....

 

[holdmusic34]

More corruption than a murder of car salesmen.

Is that the collective noun for car salesmen? A murder?

Save Ferris.

 

[amriddle01]

Crows, yes, not sure about car salesmen