Make FME by command 1

[bj2592]

Hi!
Does anybody know if it is possible to make a FME(*21*ext-nr*B-address#) on a OPI by using commands?
We have a MD110 BC10/CNA144 with about 140 extentions that is externaly diverted without any physical telephone connected. After exchange-restart/reload we have to manually program all these extensions on the OPI. We are looking for a way to program this by commands instead.
Best regards BJ2592

 

[lalrl]

Do you need internal diversion (*21*) or external diveresion (*22#)?

to divert internally: Use gh-groups with cdini instead of extension

to divert externally: Use ACD-groups with cdini to abb-numbers instead of extensions. Problem: capacity per LIM could be not enough.

 

[DUFQI]

why not using "generic extensions" with "personal number"
needs licenses

 

[HIREI]

IMHO: You can do this from another extention using the same procedure as you mention, according to User's Guide of DIALOG 3199. The guide now is unreachable, so I can't check it. (But, of course, the telephone type doesn't matter).

 

[HIREI]

Oh, sorry. It's (above) from another opera, written by mistake.

 

[ceejay55]

You can set up Common Abb Numbers and only the opi will be able to use them-you will still have to dial 140 numbers but still easier than *21*extn no*etc
best way is generic extn and pelpi but i dont think this is saved in reload data anyhow until later versions of BC11
Regards