M3505 PHONE install

[bochieboy]

I want to replace some m3505 rls 1 phones with m3505 rls 3 phones, is there anything I need to do on the switch, in OTM or is it just plug and play?

 

[bochieboy]

I am sorry I meant m3509!!!

 

[TedSobo]

The easiest thing to do is unplug one phone and plug in the other and see if it works. Seriously, if you just replace an acd 3905 of one release with a 3905 of another release you should have no problems.

 

[bochieboy]

Thanks for the response, I tried one and had a couple of issues, I am going to try another and what happens. Thanks again.

 

[Nortellian]

if there are issues you can go to ld 32 and do a fdlu tn on that unit.

 

[mluckie1]

What is the software rls of the PBX?

 

[bochieboy]

Thanks Noretllian. Mluckie1 we have an opt 11/succession 3.0, I hope that is what you are referring to.

 

[Telephonist]

Prior to my Succession 3.0 upgrade, while at X11 R25.30, I had a problem with one Phase 3 M3905. I did a flash "downgrade" to my release level, and the problem cleared.