Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lpu5

Status
Not open for further replies.

Vivek1666

Systems Engineer
Mar 10, 2021
17
IN
I am having problem that lpu5 card is restarting again and again
 
so system is 101 or 104 and after that restart or what?
what is show in log display


PG4E
 
From 12 march itself epabx is working fine, but now digital lines are hanging

i done soft reset by RFEXI LPU Display showing 114 and working as of now
 
Run syardump
Sddsc:lim=?; all lim
Then after reload check with sddsp and when you valid one with update date use sddsi:lim=?; ... then send 4 lim file
 

<SDDSP:LIM=1;
SYSTEM DIAGNOSTIC SYAR DUMP STATUS
LIM LCSIDE DUMP DUMP DUMP DUMP LCACTION
DATE TIME REASON STATUS HISTORY
1 EXE 12 APR 2021 13:41:24 WATCHDOG RESET RELOAD FRESH 0
UNCERTAIN 0
0
0
0
0
0
0
END

<
 
SO you have reload request in lim1
SDDCI:LIM=1,LCSIDE=EXE,FILE=lim1;
or
SDDCI:LIM=1,FILE=lim1;
then copy from sysn/usr1/ses/sd and attach here.

PG4E
 
What will be solution if a pin in cabinet is broken where anologue extension card was inserted, is there is any solution, if there is any problem
 
just with solder or leave that slot position empty be carefully about short circuit ...

PG4E
 
What will happen if we insert anologue extension card there, an analogue extension card is working in that slot
 
IF WORKING no prob but carefull about more pull/push boards/...

PG4E
 
what was the problem if synchronisation fault in lim appears AND i need one more TMU card is light is blinking

 
with mddt md disk tool you can find that on sam folder

PG4E
 

<CADAP;
CALENDAR DATA
IDENTITY=BILLROTH
VERSION=CXP1010101/4/TSWSP02/R3A
CALENDAR TIME NOT VALID
18:58:04
MON 19 APR 2021
END

65 SYNCHRONIZATION FAULT IN LIM
DATE TIME ALP NOIF EQU INF1 INF3
19APR21 19:16:22 10 1 001-*-**-** 1 2
RDATE RTIME
19APR21 19:16:37



<SCICP:LIM=1;
NOT ACCEPTED
COMMAND NOT IN USE


<SCEXP:LIM=1;
EXTERNAL SYNC RECEIVING LINES DATA
MASTER LIM STATUS [MASTER SCOPE]
FIRST CHOICE 1-0-40-0 SYNC RECEIVING
SECOND CHOICE 1-1-30-0 OK
THIRD CHOICE NOT PRESENT


ANY SOLUTION FOR THIS CALENDAR TIME NOT VALID AND SYNCHRONIZATION FAULT IN LIM
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top