Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Loudspeaker Page All set up

Status
Not open for further replies.

Klees

Technical User
Jun 10, 2008
190
US
I have wats trunks for each paging zone in 2 locations. I was told I cant have "page all" but i see it under loudspeaker paging. How do I set that up? add a new wats trunk? does it need a port? thanks!!
 
Hi,

Each Paging zone needs a port to be assigned and you need to look at feature access codes if you want to page zone wise separately. If you have access to system, commands to look at would be "display system feature-access" and "display system-parameters features" as well.
You would need a new trunk group if you have a separate paging system that is connected via the trunk group. If you want to use avaya phones for this feature, then you would not need a port/trunk group, instead you can create paging groups and use the loudspeaker paging feature.

Hope this helps.

Thanks
 
If you have two separate zones with different amps then you can check for a second input on the amps. If you have paging control units, look for for an override input. The paging equipment manuals are you best resource. Build a new trunk group for all page and connect it to both second/override inputs.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top