Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Loud Bell in remote factory via fibre???????

Status
Not open for further replies.

james1982

Technical User
Nov 14, 2003
441
GB
I have the following problem:-
3300 mxe MCD4 in building A.
Fibre link to building B which is a factory- numerous IP phones here.

I need a loud ringer / bell in building B's factory that simultaneously rings when an IP phone in an office rings.
Normally I would use a standard analogue bell via an ASU - as this is a remote factory over a fibre link this isint possible.

Apart from installing a long structured cabling run is there any other options??
 
After following the doc described above from MOL I have got the unit working, as mentioned by mitelpassion you only really need to configure IP of the controller, the extenions and password to register.

A good bit of kit but a little fiddly to configure, definatly not an out the the box plug and play device!

thanks again for all the assistance.
 
good that it's working.
tell you I'd rather configure the Linksys PAP than Mediatrix ;)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top