Have a queer problem. I just put together several reports and for some reason, after i go to page setup and set the margin parameters for the reports, they seem to lose the settings. the printer used is a HP4050 laserjet on the network. I can get the report in either design or preview mode and then set the margins so all the text lays on the report, then either print (prints fine if i print from preview mode after setting the margins) or save the design and the next time i open the report the margins are all 1" (one inch).
can't understand why this is happening ~ anyone ever had a similar issue??
oh, am using access 2000 (compacting and reopairing has no affect ) also, i tried setting margins on a word2000 document to the same as i am doing in access and have no problem maintaining the settings no matter how many times i open the document in word.
thanks
Paul
can't understand why this is happening ~ anyone ever had a similar issue??
oh, am using access 2000 (compacting and reopairing has no affect ) also, i tried setting margins on a word2000 document to the same as i am doing in access and have no problem maintaining the settings no matter how many times i open the document in word.
thanks
Paul