Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Loop won't come up

Status
Not open for further replies.

Ski123

Technical User
Mar 21, 2008
239
US
I am having a problem with a loop that will not come up. It is on anolder 81C. I have tride replacing the QPC464 buffer card and also the QPC414 Network card. When doing a status in LD32 I get a CTYF:98 . The starnge thing is that loop 99 shares the QPC414 and I was aslo getting the CTYF:99 but was stil getting dial tone. After repacing the QPC414 I don;t get the CTYF anymore but still have no dial tone on Loop 98. Both the lights are lit on the QPC464.I also tried removing all the line cards and bringing the loop up. The loop does enable and disable when I issue the commands but still no dial tone on Loop 98 . Any suggestions?
 
You should also unseat all cards except for the buffer and try one card at a time. One shorted/bad line card could cause your problem.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top