Looking for digit translation table

[rongill]

Well I think thats what I am looking for.

Our main number is xxx-xxx-0808 and that can't be programmed on a phone because of the 0. So our vendor programmed DN 8080 on the phone and said he did some translations in the CS1000.

Any idea where I can find this?

 

[bigindian65]

prt your IDC tables in overlay 49

Mato' Was'aka

 

[rongill]

I see a few digit translations in there just not that particular one.

 

[bigindian65]

what do you get if you prt DNB 8080 in ld 11

Mato' Was'aka

 

[rongill]

just the phones on which i have programmed DN 8080 on.

 

[GHTROUT]

IDC tables can take "prefix" numbers. so you might see:

0 8
or
08 80
or
080 808

[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators

 

[rongill]

nothing of those number combinations are in that table.

 

[GHTROUT]

Then xxx-xxx-0808 is a trunk, and the translation is done via Auto-Terminate - and 8080 may be found on the ATDN prompt of the trunks.

[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators

 

[rongill]

do you know where i can do a printout of these. I'm using the CS1000_File_Cabinet.mdb and haven't seen it in any of those prints.

 

[bigindian65]

have you printed your ATT_Data in ld 21, verify what ATDN is pointing at

Mato' Was'aka

 

[trvlr1]

Also, are you sure that is the digits the telco are sending you? The number you call may be 0808 but the telco can also change it to deliver any digits they want to your system. In this case they may be sending 8080 to you.

 

[GHTROUT]

Find the trunk TNs, print the trunk TNs.

In the file cabinet, it's LD 21 LTM and then LD 20 TNB


[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators