Loading Deplists 4.5 CP

[rookie13]

I have the deplists in a floppy. Can anyone please tell me the command to load it.

TIA

 

[tnphoneman]

What cpu are you running?

If you have a floppy drive place the disk in the active drive.

LD 143

.MDP INSTALL F0\filename.zip

Be sure to change the file name to an 8.3 format or this will not work. I always change it to patch.zip and place the file in the root of the disk. Do not unzip the file.

Now wait......then wait some more.....Best to do this from the active Core TTY as you will be able to see what is going on and watch the progress. It will not show the progress on the normal TTY port.

 

[rookie13]

Sorry, this is for an Opt61c with CP68060? 4.5.

 

[tnphoneman]

Then you would use the same command but would either use F0 or F1 depending on which one was active.

 

[djwht]

use mdp refresh instead of install if you have any special patches. mdp install delete all current patches, refresh will remove and update any obsolete or defective patches.

 

[rookie13]

I believed I used MDCS Install F0 or F1 before. Not sure what was the software release.

 

[tnphoneman]

I believe MDCS is the command for 25.40b and below.