I have three 8000's that jam only when feeding from tray 3. The page stops before it reaches the PS1 registration sensor below the toner cartridge. I have to open the right door to remove the page. After I clear the jam, sometimes it will print one page and jam on the second page, leaving the first page only partially ejected.
Errors from the event log are 13.3 37, 13.3 16 and 13.3 16
The service guide says to replace the registration assembly, but if that was the cause, wouldn't it jam from tray 2, also?
Here is what I have tried:
- New rollers
- Clean PS1 with compressed air
- Swapping the black spinny thing next to the bottom pickup roller with the one from tray two
- Swapping the paper tray with one from another printer
- Removing the PIU to clean the PIU sensor with compressed air
Any other suggestions?
Errors from the event log are 13.3 37, 13.3 16 and 13.3 16
The service guide says to replace the registration assembly, but if that was the cause, wouldn't it jam from tray 2, also?
Here is what I have tried:
- New rollers
- Clean PS1 with compressed air
- Swapping the black spinny thing next to the bottom pickup roller with the one from tray two
- Swapping the paper tray with one from another printer
- Removing the PIU to clean the PIU sensor with compressed air
Any other suggestions?