Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
List of availabe TN's
- Thread starter dosev
- Start date
Something to bear in mind when it comes to IP sets, Loops are defined as virtual but could be used for Virtual Trunk or IP Sets. If you do an LUVU for say 1120 it would only show the cards that are part configured with sets.
So say on Loop 200 you configured 30 sets on the first card 200-0-0-0 to 200-0-0-29 and you did an LUVU it would only show the 2 remaining TN's on that card. The other 31 cards (200-0-1 to 200-1-15) could be empty but would not be shown. If you were to stat 200-0-1 in LD 32 you would see it was UNEQ meaning you could use it.
To find out what Virtual cards are available or assign more use LD 97
REQ prt
TYPE supl
So say on Loop 200 you configured 30 sets on the first card 200-0-0-0 to 200-0-0-29 and you did an LUVU it would only show the 2 remaining TN's on that card. The other 31 cards (200-0-1 to 200-1-15) could be empty but would not be shown. If you were to stat 200-0-1 in LD 32 you would see it was UNEQ meaning you could use it.
To find out what Virtual cards are available or assign more use LD 97
REQ prt
TYPE supl
- Status
Similar threads
- Locked
- Question
