List meas for DS1

[PhoneTechMan]

Morning all, I've noticed that when I do a "li meas" on the TN464 DS1 circuit packs that comprise my DCS link the intervals are not current, they're almost a day behind. We've been having some trouble with this circuit taking a lot of hits, so I swapped circuit packs at both ends to see if I had a hardware issue. This has been going on for a couple of days now with the measurements lagging behind, and is starting to concern me. Anyone seen this before, and if so, how do you get the measurements back on time?
Thanks In Advance,
Tony

 

[wleong]

list measurement ds1 log xxx and page a couple of pages forward and you will get to the current stuff. it keeps 48 hours. another way to look at this is list measurement ds1 summary and it will also give you a 48 hour window.

 

[PhoneTechMan]

I know how long it keeps the data, what I'm saying is the data is not current as of the last interval. I've done the commands on my other DS1 packs, and they display up to the prior 15 minute interval, this one is not. It's WAY behind.

 

[orypecos]

What he is saying is that on some of the ds1 boards the most current info is listed at the end page instead of the first page.

 

[PhoneTechMan]

OK, I get that, but it's not the case here.

 

[orypecos]

I don't think that it will make a difference, but you could do a 'change ds1' and the board number, and put 'slip detection' yes.
U can also busy and release the board if you have the permissions and don't mind the span out of service.