Linux Base Install Problem 7.5

[IgnisGelidus]

Hi,

I'm trying to install an CS1000E rls 7.5 linux base on a CP-PM (2gb of ram, s5 position 2).

I've made the boot rmd CF 2gb with the software, like the manual says.

When i started the boot with boot cf, it detected that the bios was old and it upgraded to the bios vr18.
Then I've made the reset defaults to the cmos.

After that when I'v pressed the F to boot again from the CF on the faceplate, it runs, but the screen to choose the Y to start de installation simply does not appear, only appears a black screen without any possible choise, and then after some minutes CP PM makes a reboot.

Could someone help me?

Best Regards,

TR

 

[monkey101]

is this a fresh install with a new hard drive? if the hard drive was used youcan try piulling it off and wiping it so that when you start the install it will be prompting you to format the drive.

 

[IgnisGelidus]

The hard drive is a used one, but it already have been formated on my first attempt to install linux.

I've tried to pull it out, but no luck.

It only appears this screen:


Pre-Installation Script started... Please wait...


PreInstall script started. mntDir=/tmp/cf ethif=eth1

Checking for previous installation...
#################################################################
#################################################################

Installation of New Linux base Operating System

New Lin
sending termination signals...done
sending kill signals...done
disabling swap...
unmounting filesystems...
/mnt/runtime done
disabling /dev/loop1
/proc/bus/usb done
/proc done
/dev/pts done
/sys done
/tmp/ramfs done
/tmp/cf done
rebooting system
Restarting system.


Regards,

TR

 

[IgnisGelidus]

Hi all,

I've found my problem... it was the conversor usb to com.

When pluged the com cable to another computer, without any kind of converser, it worked with any problem.

I hope this help someone.

Best Regards,

Timoteo Ribeiro