I have a customer that would like to link two offices. Both are going to have the dsx80 w/ voip cards.
You can link two DSX systems together by using an unused IP extension in a remote DSX as the SIP service provider for a SIP Trunk in a local DSX. This sets up a VoIP tieline emulation between two IP equipped DSX systems. Press a DSX SIP line key in a local DSX system and dial any destination in the remote DSX. You can dial remote system extensions and Department Groups, use outside lines, and log into the remote system's voice mail.
•
To place a call to the remote DSX from the local, a local user presses the SIP Trunk line key and dials an extension or other valid destination in the remote.
To place a call from the remote DSX back to the local system, a remote user places an Intercom call to the IP extension in their own system that is the provider for the SIP Trunk in the local system. The SIP Trunk line key in the local system will ring.
The SIP Trunk in the local system can be set up as a Loop Start line or DID Wink Start line.
I'd like to be able for both systems to have full access to each other. Can I not just duplicate this on the local side for full access from remote to local???
Voice Connect Plus, Inc.
have a great day and a better tomorrow
You can link two DSX systems together by using an unused IP extension in a remote DSX as the SIP service provider for a SIP Trunk in a local DSX. This sets up a VoIP tieline emulation between two IP equipped DSX systems. Press a DSX SIP line key in a local DSX system and dial any destination in the remote DSX. You can dial remote system extensions and Department Groups, use outside lines, and log into the remote system's voice mail.
•
To place a call to the remote DSX from the local, a local user presses the SIP Trunk line key and dials an extension or other valid destination in the remote.
To place a call from the remote DSX back to the local system, a remote user places an Intercom call to the IP extension in their own system that is the provider for the SIP Trunk in the local system. The SIP Trunk line key in the local system will ring.
The SIP Trunk in the local system can be set up as a Loop Start line or DID Wink Start line.
I'd like to be able for both systems to have full access to each other. Can I not just duplicate this on the local side for full access from remote to local???
Voice Connect Plus, Inc.
have a great day and a better tomorrow