Linking a BCM400 3.7 to a Cisco call manager express via T1

[jpanzer]

Hi all:

I would like to explore the possibility of connecting a BCM400 3.7 to a Cisco Call Manager Express 2621XM router via T1 cross-over so that I can call between the systems.

Currently, my BCM does not have a T1 card in it, so I would have to buy one. My 2621XM has one.

Question is, do I need licenses to use the T1 to call between the two systems? Has anyone done this before?

Note that this is just for a lab setup, so if it's extravagantly difficult, then I won't worry with it. I do use 4 digit dialing on the BCM in the 6xxx-7xxx range and I plan on using route code 4 or 5 to route calls to the CME system.

Thanks!

 

[norstarboy125]

You don't need any kind of keycodes for a t1 on a bcm. You just need to set up your route, dest code, and target line programming and you should be good to go.

Charm City Communications

http://www.charmcitycommunications.com