You can use any terminal emulator package, such as ProCom, ASA, or ATE loaded on a PC (use 4410 Emulation) or Hyper Term (VT100), connected to the TERM port on the back of the cabinet with an RS-232 cable or use the same emulator to dial into the INADS port.
The terminal that died had a 25 pin cable connected to that. If I through and adapter on that to make it a serial port and plug it into a PC, and use ProComm loaded on a the PC, should that do the trick?
715 bcs or 715 gbcs2 is a much better replacement for the Max 900. Especially if it doubles as your Audix admin terminal.
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
Avaya. Too little or no help? Expensive?
For FAST switch support at bargain rates, give bsh a call.
Plus you can Remote Desktop to the PC now if you put it on the LAN. Assuming the only reason the terminal was an issue was because you have a pre-9.5 system without direct LAN access.
Plus you can Remote Desktop to the PC now if you put it on the LAN. Assuming the only reason the terminal was an issue was because you have a pre-9.5 system without direct LAN access.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.