running MCD 7.0 SP1 PR1, and when I install a LIM on a 5330E set and tell it "Failover only" is set to NO, I never get the prompt to "select program key" to program a line key for the line interface. Anyone come across this yet or know what I may be doing wrong? Followed the LIM instructions word for word.. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
line interface module on 3300 5330E set
- Thread starter wacker43
- Start date
Waldosworld
Vendor
Did you save the configuration in boot load first, then try adding the line?
- Status
Similar threads
- Locked
- Question