knight1811
Technical User
Just got the Leadtek GF4 ti4600 card.
I removed my older GF3 ti200 card and install the new Leadtek card.
After installation, I start the system and get nada. I get a series of beeps from the PC speaker and then nothing is displayed on the monitor. I noticed that the A drive (3.5) lights are on and do not turn off. I think the card is bad.
Anyways, I removed the card and reinstall the GF3 ti200 card and it loads up perfectly. I then remove the GF3 ti200 card and reinstall the GF4 Ti4600 card and the same results (series of beeps and nothing on the monitor).
Basically, the POST test doesn't complete thus no display on the monitor screen. I only get an audio alert and then it just "hangs." Any ideas?
thanks and happy holidays,
Jae.
I removed my older GF3 ti200 card and install the new Leadtek card.
After installation, I start the system and get nada. I get a series of beeps from the PC speaker and then nothing is displayed on the monitor. I noticed that the A drive (3.5) lights are on and do not turn off. I think the card is bad.
Anyways, I removed the card and reinstall the GF3 ti200 card and it loads up perfectly. I then remove the GF3 ti200 card and reinstall the GF4 Ti4600 card and the same results (series of beeps and nothing on the monitor).
Basically, the POST test doesn't complete thus no display on the monitor screen. I only get an audio alert and then it just "hangs." Any ideas?
thanks and happy holidays,
Jae.