LDK-20 Inbound DID routing not working properly

[2311angel]

Hello all,

I have an LDK-20 that is behaving in a strange way. I have 3 DIDs linked up to be sent to the VOIM, and then be pushed through to Hunt Group 620. Strangely enough though, only 1 number is working. The other 2 numbers are configured to travel to the VOIM, in the web portal, and they are all set in the Flexible DID table as well.

I can't work out why 1 is working when all 3 are set to do exactly the same thing.
If anyone could shed some light on this, I would be grateful


Thanks,
Angel

 

[Thermus]

Have you set up the other 2 numbers in the voim "SIP attributes 2" page? If they are not there, the system won't accept the call

 

[2311angel]

The other 2 numbers are there, but the system is not receiving the call. Do you know of a way to check active registration on an account to make sure it is registered properly?
Also, what is the difference between "Register" and "Provision" in SIP Att. 2"?

 

[Thermus]

Hi Angel

The registration/Provision story is a long one. It also depend on how your SIP provider is sending you the calls.
On LDK I found that registration requires a password for each number, Provision did not.

However with regard to your missing DDI numbers, I would suggest getting to know Wireshark. Get a switch that can do mirror porting and you should be able to see if the calls are getting to your system at all.