LDK-20 Fax Xfer

[2311angel]

Hello!

I am going to set up a fax machine on my LDK-20 system.
From searching on forums, and reading programming and feature manuals, I think I have it down pat now - but I want to be sure.

Auto Fax Xfer works on the last SLT Port, SLT8, in my programming, is Station 218.
Connect the Fax to 218 - Enable Data Line Security, Turn on FAX Mode on Stn 218.
Set Hot Line to CO Line 8 (Physical landline is CO 8, all other lines are VoIP)
Set Auto Fax Transfer to CO Line 8, enable Fax Tone Detection, set Fax Tone Detection timer to 5 seconds.
On the Fax, set it to FAX ONLY mode to allow it to automatically receive a fax with no input



I am also under the impression the calls will follow this path:

[Call on CO 8] --> [System answers and plays RBack tone to caller,| --No tone detected--> [FWD to CO Ring Assign for CO 8]
...........................|Listening for Fax CNG Tones for 5 seconds ] --CNG tone detected-> [FWD to Fax Station 218]

If the system hears the fax tones, it will pass the call to Station 218 (Fax station)
If the system doesn't hear fax tones after 5 seconds, it will pass the call to the assigned ringing stations (210, 212[delay 4], 217, 219, 230).


Is this all correct? Am I missing anything?

 

[2311angel]

Reporting back to state that a test fax was sent and successfully received with the above mentioned setup