LD 80 call trace in Option 11

[altolabado]

For some reason on the Option 51c I can use ld 80 to trace calls see the route it goes on, however when i do this from the Option 11 it wont allow it spits out

.tra120

.tra101

 

[johnpoole]

what command are you using in the 11? it should do a trac just as easy

john poole
bellsouth business
columbia,sc

 

[Nortellian]

use trak

 

[altolabado]

Thanks.... trak works but i don't get what this means.....
______________INDICATED WITH >>> AND ???????___________

TN 035 0 00 04
KEY 0 SCR MARP ACTIVE TN 035 0 00 04
ORIG 004 19 TIE RMBR 15 19
TERM 035 0 00 04 0 SCR MARP 0 4275 3903
DIAL DN 4275
MAIN_PM ESTD
>>>TALKSLOT ORIG 17 TERM 17 ??????
EES_DATA:
NONE
QUEU NONE
>>>CALL ID 0 223 ??????
>>>NETWORK CALL ID 0 1010??????

COS_ORIG CTD COS_TER CTD
TGAR_ORIG 1 TGAR_TER 1
NCOS_ORIG 0 NCOS_TER 1
EXP_ROUTE NO

The following WHY ISDN??
---- ISDN PRA CALL (ORIG) ----
CALL REF # = 19
BEARER CAP = VOICE
HLC =
CALL STATE = 10 ACTIVE
CALLING NO = 9058478439
CALLED NO = 1004275
______________________________________________

 

[senk1s]

what are you trying to do? learn or is there some troubleshooting you are doing?

if you are just trying to see what #s were called, enable cdr and capture the serial output with procomm/ hyperterminal

oversimplified explanations:
talkslot - is where is voice gets switched. and is dynamically assigned by the processor/switch.
Potentially each call can end up in a different time slot

call ID is like the social security # for that call - it helps the switch/processor to identify the call

 

[MERIDIAN11C]

trad is for dti
trak is for Co trunk
trac 0 plus the DN and you trace the extension