Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
LCR software question
- Thread starter Joyz
- Start date
How do you mean? Have you looked for the program units?
CNPIP:UNIT=XXX;
Where xxx is:
LRH for Least cost routing commands
LRP1 for External Number database
LRP2 for Number length database
LRP3 for DNT1 database
LRP4 for Time of day database
LRP5 for American market
LRP6 for DNT2 database
LRP7 for DNT1 and DNT2 overflow database
If these units are not loaded then get your service provider to load them.
CNPIP:UNIT=XXX;
Where xxx is:
LRH for Least cost routing commands
LRP1 for External Number database
LRP2 for Number length database
LRP3 for DNT1 database
LRP4 for Time of day database
LRP5 for American market
LRP6 for DNT2 database
LRP7 for DNT1 and DNT2 overflow database
If these units are not loaded then get your service provider to load them.
- Thread starter
- #4
r u sure u dont have lcr as i understand it to be loaded as a default the quickest way to try is lcddp or try and set 9 as lcr access code with nanse:numtyp=ed,numse=9;
nansi:numtyp=lc,numse=9;
obviously it would have to be done out of hours to minimize disruption to the switch
nansi:numtyp=lc,numse=9;
obviously it would have to be done out of hours to minimize disruption to the switch
whosrdaddy
Vendor
in the past LCR was not loaded by default. if the customer wanted LCR they must pay $$$ to activate this feature. with the new licensing model this isn't needed anymore so LCR soft is loaded by default
- Status
Similar threads
- Locked
- Question
- Locked
- Question