Large LED Light Change colour

[LeeEng]

I am wondering if there is a way of changing the colour of the large LED light to flash a different colour depending on the Department call coming in. I currently have the following set up

Red - All Internal Call
Light Blue - External Calls

Wondering if I can have 2 different colours for my 2 different department calls. they will both be internal calls.

 

[belevedere]

Which system and what phones? Digital or IP?

 

[LeeEng]

System is the SV9100
The phones are UT880's
running only SIP

 

[belevedere]

MB 1572:
DT500/DT400 Large LED
Illumination Setup – Internal
Incoming
2 = Red
3 = Green
4 = Blue
5 = Yellow
6 = Purple
7 = Light Blue
8 = White
9 = Rotation
But this is for the phone and not by dept. GP. It may also work for th UT-880.

 

[LeeEng]

@Belebedere thanks for your reply.
I understand this part but it only does it phone by phone for internal calls to that phone. The UT880 phones don't do different ring tones for Internal/external call like the DT700 phones do. I am trying to find a solution to be able to distinguish between internal calls and door phone calls.
My door phone is a Fanvil i10 and I use the department group so all phones ring when someone is at the door, it would be nice if I could make the Large LED flash green as at a glance we can see its the front door and not and not an internal call.
We are also planning on adding another Fanvil i10 to the side door and would like this one to flash the LED orange.

 

[OzzieGeorge]

Couldn't you just make the doorphone ring a virtual and then have the Virtual appear on a key on the phones? You could have a different key for each doorphone.