Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lantronix UDS config Settings for telnet access

Status
Not open for further replies.
id07355

id07355

Technical User
Dec 16, 2003
38
US
Is anyone familiar with the configuratino settings for a Lantronix UDS-10 that is used for telnet access to an Octel250/350?
I am looking for teh correct port settings to allow telnet access.

Anyone?

id07355
 
Sort by date Sort by votes
In the UDS 10 you just tell it that the RS 232 is 9600 8 n 1 and assign the IP address to it and tell it what port to use. You can use and port you would like but we always use 3001 then configure the ProComm plus for telnet with the ip address of the UDS and the port number and bam you should be in. Make sure the async port on the Octel is set to 9600.

Ken Means

 
Upvote 0 Downvote
Thank you for your reply, i found out the correct pinout for the cable finally. Turns out it was that simple.

Thank you for your help.

id07355
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

doktor
  • Locked
  • Question
Remote Service for OCTEL 200/300 and VMX-100
Replies
0
Views
167
doktor
doktor
bluerigsby
  • Locked
  • Question
Need to find a UK maintainer for Octel 250 2
Replies
7
Views
240
MurrB
MurrB
OldPhoneLady
  • Locked
  • Helpful tip
Good Source for Octel Parts
Replies
1
Views
104
KenMeans
KenMeans
rondussault
  • Locked
  • Question
need direction setting up phone tree for auto attendant octel software 4.0.0.2
Replies
3
Views
122
doktor
doktor
rondussault
  • Locked
  • Question
setting up a mail box for messages to go to another mail box
Replies
4
Views
134
doktor
doktor

Part and Inventory Search

Sponsor

Back
Top