Lan speed setting for Audix and CMS

[phoneguy55]

Moving all my IP interfaces to new LAN switches so that I can do QoS. To make it simple, I am just going to migrate everybody including CMS and Audix. My clans and medpros are all going to be forced to 100 full.

My question is, what speed do I set the lan switch for on my Intuity Audix MAP 5 R5.1 and CMS R12? 100 full, 100 half, auto?

 

[mikeydidit]

The ports on our gear is set to auto for my intuity, CAS System and Switch. That should work for you.

Mikey

 

[jeffrclark]

How do I give an IP address to my clan card? does my med pro card need an IP?

 

[mikeydidit]

The command for the c-lan would be "ch ip-interfaces. I am not sure for the Medpro (I dont have one) but I would think it would be the same.

Mikey

 

[nath42]

ch node-name ip to set up the IP address
ch ip-interface to set up the subnet mask/gateway/network region
ch eth to set up your ethernet options (including the speed)

You can do this for any IP card : CLAN, MedPro, VAL

 

[SBL110]

Just an FYI:
I had the Intuity where I work set for 100/full and the switch as AUTO. A tier three tech told me they prefer Audix to be 10/half on both ends.

We have an Audix MAP 40 software rev: 5.1-37

SBL110