LACP TRUNkING PROBLEM ON 5406ZL and 5308XL

[phjohnso]

I am having trouble getting lacp trunking active on all 4 ports between a 5406ZL and 5308XL procurve switches.

the 5406 has ports b1-b4 marked as lacp active

the 5308 have ports b1-b4 marked as lacp passive

I issue the cli command

trunk b1-b4 Trk3 LACP on both switches

my result after the links come up on both ends are that the ports on each side are marked as lacp active and only B! in the tunk group is up with lacp partner as yes and lacp status as success.

no matter what I have tried I can not get more than one port active in the lacp trunk group.

Need helpful thoughts here to get this running.

Thanks in advance.

 

[phjohnso]

More details

the commands on the 5308xl are below - note that the no lacp command gets put in automatically and I can't remove it

interface B1
name "Link to NS-TRM-TR115a Port B1"
speed-duplex 1000-full
no lacp
exit
interface B2
name "Link to NS-TRM-TR115a Port B2"
speed-duplex 1000-full
no lacp
exit
interface B3
disable
name "Link to NS-TRM-TR115a Port B3"
speed-duplex 1000-full
no lacp
exit
interface B4
disable
name "Link to NS-TRM-TR115a Port B4"
speed-duplex 1000-full
no lacp
exit
trunk B1-B4 Trk3 LACP


On the 5406ZL the commands enters are.

interface B1
name "Link to ns-intlnk-cso-tr105-R2 Port B1"
speed-duplex 1000-full
exit
interface B2
name "Link to ns-intlnk-cso-tr105-R2 Port B2"
speed-duplex 1000-full
exit
interface B3
disable
name "Link to ns-intlnk-cso-tr105-R2 Port B3"
speed-duplex 1000-full
exit
interface B4
disable
name "Link to ns-intlnk-cso-tr105-R2 Port B4"
speed-duplex 1000-full
exit
trunk B1-B4 Trk3 LACP