Labeling tape while backups running causes fsf errors on 6.2

[rogercase]

Im running a STK9710 with 6 SDLT drives. While backups run flawless until I need to label a tape, once the tape is labeled and does verify and moves 1 all other drives with backups in progress hit the fsf error and then they are marked full resulting in needing a new tape.
I have checked all cables, used new tapes, and still same error happens every time. I can label without backups going on and its fine. Any ideas out there?????

 

[jgarmer]

What is your scsi layout tape labeling on same bus as fsf drives? Also is your firmware on sdlt 4.6?

joe

 

[rogercase]

only 1 drive is 46 all the scsi is daisy chained for all 6

 

[rgzimmer]

Are you seeing BUS resets?

 

[rogercase]

Yes and all cables are secured and looking good

 

[rogercase]

firmware 4.6 did the trick!!!! thank you!!!!