KX-TDA100/200 Caller ID on SLTs 1

[Tehrani]

I am trying to get my SLTs to show caller ID.
The system is configured as below:
1)BRI4 card
2)LCOT8 with CID8 card
3)DHLC8
4)SLC8 with CID-EXT card
5)DHLC8
After many days of perseverance I managed to get the SLTs connected to the SLC8 to show caller ID, (The SLC8 card needed software upgrade to achieve this.)

Now I’m stuck with SLTs connected to the DHLC8’s SLT ports.

Can any one guide me please?

 

[cwc3]

YOU WONT GET CALLER ID ON THE THE DHLC

 

[Tehrani]

I was kind of getting that feeling; at least I'm put out of my misery. Thank you, I can have a good night sleep now.
Ironic, how Panasonic quote “CLI on SLTs”….. :-(

 

[cwc3]

it only works on 8 port slt cards that have the add on
cid card

 

[Tehrani]

I did add the cid card to the 8 port SLT card, but it did not work until I upgraded the software on SLC8 card.

On the same note, I notice that the DHLC card has an identical socket as the SLC8 card has for the CID card. I know that the SLC cards and the DHLC cards share the same PCB, so what would happen if a CID card was plugged into this socket?

 

[cwc3]

whats your manual say?

 

[brokeda]

Check the website. All required upgrades are there.
As for the DHLC and Cid, give it a try.