KX-TD816e 1

[rebgershon]

I have just purchased/commenced installation of a UK model TD816.
I decided to clear all the existing programming by doing a clear/reset.
I have 7 terminals/extensions 1 x KX-T7433, 6 x KX-T7431.
What are the default settings for the extension numbers when dialled as I can't seem to find this info anywhere in the manual i.e. for extensions 1 - 7 what do I dial from the other extensions?

TIA,

Geoff.

 

[Otoni79]

KX-TD816: Default

01-1 to 16-1= 101 to 116
01-2 to 16-2= 201 to 216

 

[rebgershon]

Thanks

 

[obtsystems]

If it is a uk model 1-1 to 16-1 = 201 to 216 and 1-2 to 16-2 301 to 316. But the 3xx numbers won't work unless xdp is off

 

[rebgershon]

Thanks, I tried Otoni's suggestion but each station reported invalid,, so I tried 20x before seeing the last post and that worked.
I was going to try the Panasonic DOS programmer tool which I downloaded yesterday from a Polish site, E1232A, after a google search. Does it require a null modem cable to connect to a computer? If so, is this the same cable used for the old Laplink if anyone remembers it?

TIA,

Geoff.

 

[obtsystems]

I wouldn't think the polish software would work. what version system do you have.
dont know the laplink, but you will need a serial 25 to 9 pin connector and a com port on your pc
all programming on the td can be done through ext 201 by default

 

[rebgershon]

Its not polish software they have a complete list of versions of the software all in English and genuine Panasonic here is the link

http://chomikuj.pl/novajan/Dokumenty/wersje+softu+nadzoru+Panascnic+TD1232.

I will try programming from ext 1 as you suggest, thanks.

 

[obtsystems]

Try it if you have the correct cable, it will either work or not, just make sure it shows the e suffex on the software