kx-td1232 just working slave mode

[lexer]

Hi, I've got two kx-td1232 working as master and slave, I'm taking the slave kx-td1232 for use it in another office, I'm trying to setup the former slave for working alone as master in the other office, I put master/slave to master position and made the clear procudere putting switch and clear position and resetting the PBX but the kx-td1232 always stars as slave, The firt jack 1-01 has the extension number 133 and cannot enter to programm using *#password, I tried turning on the pbx with switch in clear mode and after a few seconds set it to Normal, But It didn`t work, please anyideas in how to reset kx-td1232 and use it as master?

 

[omonat]

1. Set the Power Switch to the "OFF" position.
2. Set the System Clear Switch to the "CLEAR" position.
3. Plug the AC power cord into the system and an AC outlet.
4. Turn the Power Switch on.
5. Press the Reset Button with a pointed tool.
(The power indicator will flash.)
6. Slide the System Clear Switch to the "NORMAL" position while the power indicator is
flashing (within approximately 10 seconds).
The system will be initialised with default values.
The system will also check the outside lines,
extensions, and optional cards and units.

Wanet Telecoms Limited

 

[lexer]

Thanks omonat, I did it but It doesnt't work, Is there another way for resetting? I don't know by removing something inside the PBX like a battery or descharging a capacitor?

 

[omonat]

You may have to generate a default file from the console and try to upload it

Wanet Telecoms Limited

 

[kizo]

Try Master/Slave switch moved multiple times, it may have oxidized contacts.
If the year on LCD is 1993, PBX is clered.

 

[Essamtelcom]

Change cpu card from one to other ...