Konftel 300WX IP DECT 10 (AKA B169) 1

[budbyrd]

I have setup plenty of Third Party SIP devices with very few glitches. This one is IPO R11.0.2 with a Konftel 300WX. Usually it is dog dumb. Build the ext with a password at the extension level. Create the user. (Also have all passwords set in the user trying to make it work) Plug it in. Watch it pull DHCP. Verify the address by surfing to the config page. Set the user as the ext, enter the ext number, password, and the registrar IP. Reboot and bang, it works.

This one I can't even see it trying to register. Wonder if I am missing something in the Konftel setup or if something has changed in R11 that might be rejecting it. Already have J179s hanging off the IPO, so I know I shouldn't have a registrar problems.

Any suggestions?

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'

 

[Okkie26]

Did you enable 3rd party IP endpoint at the extension 'port' in the IPO?

 

[budbyrd]

Okay. Solved my own problem after banging my head for two hours.
For future head bangers. On the extension page of the Konftel you have to select the ext and go clear down to the bottom of the page and and tel it to register. You would think it would do it automatically after a reboot or power cycle (tried doing that til my fingers bled) But no...


Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'

 

[budbyrd]

In the IPO there is only a 3rd party auto answer for adding them to a page group.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'