Konftel 200 wont flash on MICs 2

[stivtaber]

Hi guys ran into this the other day, any thoughts;

Installed a Konftel 200 on a Nortel ATA attached to a MICs at ext 247.

When I try to do a three way conference call I cannot get the Flash to work. I press the flash button get silence, then no dail tone. Pressing another key brings me back to my first connected call.

I have succesfully flashed and gotten dail tone by pressing *70 after the flash. I am unable to figure out how to connect the calls though. I assume flash *??.

Cheers,

stiv

 

[curlycord]

You need to use analog feature codes.
Flash * = Feature
So to transfer a call Flash * 70

Conference is a little different.
Try Flash *2 to put a call on hold.
Make second call and then Flash *3 to conference the calls.


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[stivtaber]

Tried Fl*2 and Fl*3 doesnt do anything. The only thing that gets dail tone that I've tried is Fl*70, when I try to dail a number though I get a busy signal. And I cannot go back to my already connected call.

 

[jerryreeve]

check out faq799-5351
and make sure that the ata has 2 intercoms assigned to it.

----------------------------
Hill?? What hill??
I didn't see any $%@#(*$ Hill!!
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com

 

[RikRodgers]

I think jerry's got your answer with the additional int path.

If you're trying to do a flash transfer, or CO conference, though, use Flash*71.

 

[stivtaber]

Actually got it working using Flash *79 (exclusive hold) for new dail tone, then flash *3.

It seems to me this is a new thing though. I recall doing a similar install around Christmas at a couple of different sites on MICs and CICs with no problems at all with the flash....

Cheers

 

[RikRodgers]

Interesting.

Thanks for the follow up.

 

[curlycord]

My error was stating Flash * 2 when it is actualy Flash 2 (no star), sorry.


=----(((((((((()----=
curlycord

http://www.curlycord.com