keystrokes for disconnecting the last addition to a conference. 1

[dooner62]

hey everyone,

i do not have access to a system but i need to know the exact key strokes to do the following.

I (person a) have 1 person on my phone (person b) , i conference in another person (person c), this is fine i can do this, but now i want to do the following:

disconnect (person c) without hanging up on person (b). i dont care if (b) is put on hold temporarily, i just need to know how to ultimately end up with the initial caller.

the ***EXACT*** KEY STROKES please.

 

[bigindian65]

I do not believe with ao3 or ao6 you can pick and chose who to drop, other than yourself.

Mato' Was'aka

 

[yyrkroon]

You need the feature call Selectable Conferee Display and Disconnect.

You need to have this feature enable before you can perform the task that you have described above.

Normal conference via the AO3 or AO6 does not give you the ability to select whom you want to disconnect.

 

[trvlr1]

.... tell person C to hang up .....

 

[Reusser]

Selectable Conferee Disconnect
With Selectable Conferee Disconnect, a Meridian Modular set user scrolls
through a list of active conferees, using a Conferee Selectable Display (CSD)
key. The CSD key is configured at a set level.
Selectable Conferee Disconnect is activated when the CSD key is pressed
during an active conference. Every conferee involved in the conference, with
the exception of the CSD key user, can be displayed one at a time on the CSD
key user’s screen.
When the CSD key is in use, the display format of each conferee follows the
existing simple two party call display. The display shows the name and
extension number of the conferee. If the conferee is on a trunk, the display
shows the trunk group access code and the trunk member number.
Once the CSD key is activated, the key user can selectively disconnect a
displayed conferee from the conference by pressing the active call key. The
active call key is the key on which the conference is established. Also once
the CSD key is activated, the CSD key user can cancel the Selectable
Conferee Disconnect operation by pressing the Release key.
When the CSD key is pressed, the last conferee to join the active conference
is displayed first. Subsequent pressing of the CSD key displays the other
conferees in no particular order. With each press of the CSD key, the conferee
list scrolls in a forward direction. Therefore, if the CSD key user scrolls past
the desired party to be disconnected, repeated pressing of the CSD key brings
the user to the desired party again.
The CSD key lamp is lit when the CSD key is activated. If, however, the
displayed conferee cannot be disconnected, as in the case of an attendant
console, the Key lamp flashes. The display screen remains unchanged and
continues to show the same conferee on the display.

 

[BillCorv]

If you are using an analog phone, as used in some conference rooms.
Flash the hookswitch for dial tone and dial SPRE 87 to disconnect the last trunk added.
My SPRE code is 1, so I would dial 187
If your conferenced call ended up in a Meridian Mail or Call Pilot mailbox, dial #83 to end your message and disconnect.