key board and mouse not working

[jeter]

Intial startup I can use the keyboard, however when the blue screen showing the service pack comes up I see the ( locks key flash ) . When NT boots up I can not use the keyboard nor the mouse . ( I Blew it up HHEHEHHAHAHA ). Any suggestions is
appreciated , Thanks .

 

[dm7941]

check to make sure the keyboard and mouse are not reversed, I know it sounds wierd, but with ps/2 devices it is possible for the keyboard to work in the mouse slot, then error. Also, have you installed any mouse or keyboard software, like the intellimouse software or internet keyboard software? If you have, you may be able to get in using VGA mode or last known good configuration. Good Luck!
David Moore
dm7941@sbc.com

 

[jeter]

I went to this site

http://www.netcerts.com/downloads/downloads2.htm

and downloaded some items ( trace route,tftp server cisco,ip subnetting, Visio icons , and isdn trace ). I had to re-boot and every since it has not worked !!!!

 

[dm7941]

will it work in safe mode? If it will, then you will be able to un-install those apps and try it.

David Moore
dm7941@sbc.com