KEM on a SRG 1.5 off CS1K

[dwats9]

I am trying to get a KEM module on a IP 1120 set to register on a SRG 1.5 but all I get is v115 on the KEM and it won't work. When I register the 1120 directly to the CS1K, it works fine.
Any help would be greatly appreciated.

Dan

 

[gwebster]

For supporting 1100-series Expansion Module, you need to be running SRG 4.0 or greater on the BCM 200/400. This is because you need to be running BCM 4.0 or later to use the expansion module.

 

[biv343]

SRG 1.5 runs BCM 4.0 software. Don't know why they didn't just call is SRG 4.0.

I believe the issue is firmware related on the SRG. I had a similar issue on a SRG 50 release 3.0. See the below info.



New SRG software updates are available for BCM v4.0 (SRG 1.5) and BCM50r3 (SRG50) which contain Unistim 3.3 firmware:

For BCM 4.0, use this software update: BCM.R400.294-SRG or later (or a smart update which contains BCM.R400.294-SRG or later)

The following files are included in software update BCM.R400.294-SRG:
/nn/etc/IpSetFw/SrgMode/x00.fw
/nn/etc/IpSetFw/SrgMode/x01.fw
/nn/etc/IpSetFw/SrgMode/x02.fw (for IP Phone 2004 Phase 2, IP Phone 2002 Phase 2, and IP Phone 2001 Phase 2)
/nn/etc/IpSetFw/SrgMode/x21.fw (for IP Phone 2007 Phase 2)
/nn/etc/IpSetFw/SrgMode/x24.fw (for IP Phone 1120E)
/nn/etc/IpSetFw/SrgMode/x25.fw (for IP Phone 1140E)
Note that BCM 4.0 does not support the IP Phone 1110E and 1200 series

For SRG 1.5, apply this software update: BCM050.R300.SRG-194 or later (or a smart update which contains BCM050.R300.SRG-194 or later)

 

[dwats9]

Thanks guys, I appreciate it !