Even though i have selected overwrite existing media, when my backup job runs, it completes 99% but still send s alerts asking me to respond ok to also the tape fails to eject. even though i have checked that option in setup
DLT tape drive? or TRAVAN? Those tape drives dont support software commands to eject media. Try turning off the eject media after backup option in the job properties. [sig][/sig]
Even though i have selected overwrite existing media, when my backup job runs, it completes 99% but still sends alerts asking me to respond ok and only then ejects the tape. So Basically it takes 1 hour to back-up, and waits 10 hours for me to reply to the alert before job completes. Using dat24 and bent7.3
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.