Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

JUNKtor Board 1

Status
Not open for further replies.
fdh9466

fdh9466

Technical User
May 26, 2004
16
US
Anyone ever replace a Junctor Board? Per ETAS have a defective junctor board on an option 81c, RLS 25.40b. Again per ETAS, Product Bulletin 99047 states that a "retro fit" for a QPC417 junctor board needs replacing. Any ideas?????
 
Sort by date Sort by votes
You will need to schedule. Will cause an outage until completed. I have never replaced 1 but as long as all the cables are in the right place everything will work fine.
 
Upvote 0 Downvote
Thanks 4 feedback Mluckie1, Should I power system down while I replace? Do you have any idea where I can locate procedures? I have looked through out forums without any luck and also the docs [not extensively, ;-}, but I will!!!]
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

JCO08
  • Locked
  • Question
paddle board red light on
Replies
1
Views
116
KCFLHRC
KCFLHRC
kennyjp123
  • Locked
  • Question
Replacing dual PRI with daughter board
Replies
3
Views
139
KCFLHRC
KCFLHRC
WrongWayFeldman
  • Locked
  • Question
System Monitor Board
Replies
2
Views
128
StanleySteamer
StanleySteamer
eartel
  • Locked
  • Question
Dip switch setting for SDI paddle board
Replies
1
Views
88
eartel
eartel
dogg1
  • Locked
  • Question
Changing out a Dual SDI Paddle Board to a Quad SDI Paddle Board Procedure.
Replies
7
Views
85
KCFLHRC
KCFLHRC

Part and Inventory Search

Sponsor

Back
Top