Jukebox config

[lren]

I am working on Legato Networker 6.0.1. The problem I have is I can't config my Qualstar TLS-6460 to Legato Networker. It keeps saying I need LUS SCSI driver. Does anyone know where I can load this LUS SCSI driver? How do I fix this problem? Please reply. Thanks a lot!

 

[jethroteo]

Wat platform id your NetWorker Server on?

 

[lren]

Sorry I forgot to put on the Networker server info. The networker 6.0.1 is running on Sun Ultra-5 system with Solaris 2.6. Thanks!

 

[A411]

Are you having this problem when running jb_config?
I was having the same problems running 2.7 using Networker 5.5 with an Adic unit.
I had to install the latest patches for Solaris and link the device file.
Do:
Install the lastest patches for Solaris 2.x
Install the driver pkg for Networker and search "dmesg" for the lus driver after the

installation.
Next, create a soft link called lus in /dev to /device...(to device file)
ex/devices/iommu@f,e000000/sbus@f,e0001000/espdma@f,400000/esp@f,800000/lus@0,0:0)
For reasons unknown it does not link the device file.
Then run the commands:
/etc/LGTOuscsi/lusdebug 1 (sets debug level to 1)
/etc/LGTOuscsi/lusdebug 0 (sets debug level to 0)
/etc/LGTOuscsi/inquire (lists all SCSI devices attached)
Then finally run jb_config.

Hope this helps..

 

[lren]

Thanks A411. Actually, I finally figure out why this happen. I need do some reconfiguration on the jukebox. The legato jbconfig actually pull the configuration from jukebox eprom, It works now.