dilettante
MIS
I must be doing something wrong.
I'm trying to figure out where the quotes would go when trying to run Jetcomp from the command line (in case of spaces, etc. in the path). No luck so far.
The obvious thing just terminates quietly:
[tt]jetcomp -src:"the path\and file.mdb" -dest:"the path\new file.mdb"[/tt]
Any hints?
I'm trying to figure out where the quotes would go when trying to run Jetcomp from the command line (in case of spaces, etc. in the path). No luck so far.
The obvious thing just terminates quietly:
[tt]jetcomp -src:"the path\and file.mdb" -dest:"the path\new file.mdb"[/tt]
Any hints?