Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

J100 Expansion Module not working?

Status
Not open for further replies.

rollyfig

Programmer
Jul 4, 2013
1
CA
Hello everyone,

I have a J100 expansion module install on a J169 that doesn't work ... there is only the little white dot on the bottom but module doesn't work.

I think he didn't ugrade when i install it... any clue?
 
1: Make sure that you are using the most recent set of J100 Series phone firmware. Put the bin files and, including the one for the button module onto the file server along with the matching J1xxSupgrade.txt file.

2: Check the connection. I had one JEM24 not work and then come back to life when removed and reatttached.

Stuck in a never ending cycle of file copying.
 
i had this issue yesterday. I downloaded J100-IPT-SIP-R4_0_3_1-111819.zip from support.avaya.com
uploaded the .txt & .bin files using embedded file management to the system\primary folder.
Rebooted the phones & the came up.

The problem that i saw was that the jem24 had a newer version on them than the phones. The phones were SIP R4_0_0
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top