ITG-Dongle

[Tsaf360644]

Hi folks,

I am having one spare ITG card, I just want to know, does it require dongle to activate the card and configure it.

regards

 

[Firebird Scrambler]

If the ITG card is to be used for Miran, or a Media gateway on a e.g. 1000S system then is will require a dongle.

However if the card is to be used for ITG Trunks or ITG Line, then it won't require one.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[Tsaf360644]

Hi Firebird,

Yes, I am using it as Line and Trunk cards.
When I tried to connect through direct cable to the card, its not responding.

background:- I am having this as a spare card, I need to configure this card as same as working one, so that in case if working card gets faulty, I can just easily replace this.

Can you brief me what are the things I need to do. including software change.

thanks in advance

regards

 

[Firebird Scrambler]

I'm guessing that you do have a PCMCIA card inside the ITG card?. When you are connected to a serial cable, can you capture the start up sequence for us please?. We need to know what software exists on the card as it's different for ITG Line & Trunk and also it would be specific for your PABX software release.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[Wane47]

just in case you didn't know, you have to connect to the cable connecter (ps2 type) on the faceplate, not the backplane adaptor.

 

[MagnaRGP]

You also can't simply do a hot-swap as both IP Line and IP trunk will require re-configuration of the node with the ELAN MAC Address of the card installed.