Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Issues programming trunks for TMDI

Status
Not open for further replies.

New950

Technical User
May 4, 2011
5
CA
I am attempting to program TIE trunks for a TMDI PRI card on a CS1000. I have already programmed the DDB, CEQU, DCH, Net data, and RDB. However, while attempting to program the 23 trunks in LD 14, I receive err SCH0126: "Station type conflicts with existing card.For example: In LD 11, the craftperson has attempted to provision a digital set in the same IPE slot as an existing ITG card."

Any ideas on how to remedy this?
 
Yes I have configured the RDB to reflect TIE trunks. I have also attempted to use COT
 
Any solution to this issue..

we are having the same problem.. after installing a new CS1000E, we are not able to add the pri trunks.. we receive the sch0126 error. The loop is 4. The card sits in slot 1..

we tried to add tie trunks to TN 4 0 1 x but the system responded with the above error..

advice on this please..

Cheers!
Rev
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top